● Do not install battery packs on rainy, snowy, or foggy days. Otherwise, the
battery packs may be corroded by moisture or rain.
● If batteries are exposed to water accidentally, do not install them. Instead,
transport the batteries to a safe isolation point and dispose of them in a
timely manner.
● Before installing a battery pack, check that its enclosure is not deformed or
damaged.
● Check whether the positive and negative battery terminals are grounded
unexpectedly. If so, disconnect the battery terminals from the ground.
● Do not perform welding or grinding work around batteries to prevent re
caused by electric sparks or arcs.
● If batteries are left unused for a long period of time, store and charge them
according to the battery requirements.
● Do not charge or discharge batteries by using a device that does not comply
with local laws and regulations.
● Keep the battery loop disconnected during installation and maintenance.
● Monitor damaged batteries during storage for signs of smoke, ame,
electrolyte leakage, or heat.
● If a battery is faulty, its surface temperature may be high. Do not touch the
battery to avoid scalds.
● Do not stand on, lean on, or sit on the top of the equipment.
● In backup power scenarios, do not use the batteries for the following
situations:
– Medical devices substantially important to human life
– Control equipment such as trains and elevators, as this may cause
personal injury
– Computer systems of social and public importance
– Locations near medical devices
– Other devices similar to those described above
Short-Circuit Protection
● When installing and maintaining batteries, wrap the exposed cable terminals
on the batteries with insulation tape.
● Avoid foreign objects (such as conductive objects, screws, and liquids) from
entering a battery, as this may cause short circuits.
Leakage Handling
Electrolyte leakage may damage the equipment. It will corrode metal parts and
boards, and ultimately damage the boards.
Electrolyte is corrosive and can cause irritation and chemical burns. If you come
into direct contact with the battery electrolyte, do as follows:
LUNA2000-(97KWH-1H1, 129KWH-2H1,
161KWH-2H1, 200KWH-2H1) Smart String ESS
User Manual 1 Safety Information
Issue 10 (2023-11-07) Copyright © Huawei Digital Power Technologies Co., Ltd. 19
To Next Page
Loading...