Storage Requirements
● Ensure that batteries are stored in a dry, clean, and ventilated indoor
environment that is free from sources of strong infrared or other radiations,
organic solvents, corrosive gases, and conductive metal dust. Do not expose
batteries to direct sunlight or rain and keep them far away from sources of
heat and ignition.
● If a battery is faulty (with scorch, leakage, bulge, or water intrusion), move it to
a dangerous goods warehouse for separate storage. The distance between the
battery and any combustible materials must be at least 3 m. The battery must
be scrapped as soon as possible.
● Place batteries correctly according to the signs on the packing case during
storage. Do not place batteries upside down, lay them on one side, or tilt them.
Stack batteries in accordance with the stacking requirements on the packing
cases.
● Store batteries in a separate place. Do not store batteries together with other
devices. Do not stack batteries too high. The site must be equipped with
qualied re ghting facilities, such as re sand and re extinguishers.
● After batteries are powered o, static power consumption and self-discharge
loss may occur in internal modules, which may cause battery damage due to
overdischarge. Do not store batteries in low SOC and charge batteries in a
timely manner. Permanent battery faults caused by delayed charge are not
covered by the warranty. Storing the batteries in low SOC occurs in scenarios
including but not limited to the following:
● The power cables or signal cables are not connected.
● The batteries cannot be charged due to a system fault after discharge.
● The batteries cannot be charged due to incorrect congurations in the
system.
● The batteries cannot be charged due to long-term mains failure.
● The batteries cannot be charged because the switch of the Smart Rack
Controller, Smart PCS, or main loop component is o.
It is recommended that batteries be used soon after being deployed onsite.
Batteries that have been stored for an extended period shall be charged
periodically. Otherwise, they may be damaged.
● Packaging label description
LUNA2000-(97KWH-1H1, 129KWH-2H1,
161KWH-2H1, 200KWH-2H1) Smart String ESS
User Manual 4 Storage Requirements
Issue 10 (2023-11-07) Copyright © Huawei Digital Power Technologies Co., Ltd. 61
To Next Page
Loading...