2. Check the status of the parts to be replaced.
Start SmartKit and choose Home > Storage > Parts Replacement > More >
Parts Replacement (CRU). On the CRU replacement page, complete the
check before the replacement as prompted. For details, see 6.1.3 Replacing a
CRU.
You can proceed to next steps only when all items pass the pre-replacement check
and the replacement page is displayed. If any item fails, rectify the fault as
prompted.
Step 2 Wear an ESD wrist strap.
Step 3 Press the latch on the disk module to release the handle and pull out the disk
module, as shown in Figure 6-106.
Figure 6-106 Removing a disk module
OceanStor V5 Series
Parts Replacement 6 Replacing CRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 111
To Next Page
Loading...
