Figure 6-113 Installing an expansion module
Step 7 Connect cables of the expansion module.
Step 8 Wait approximately two minutes and check the status of Power and Alarm
indicators on the expansion module to determine whether the expansion module
has been successfully installed. Figure 6-114 shows the locations of Power and
Alarm indicators on the expansion module.
● If the Power indicator is steady on and the Alarm indicator is
o, the
expansion module has been successfully installed.
● If the Power indicator is o or the Alarm indicator is steady on, the newly
installed expansion module is faulty, the slot for the expansion module is
faulty, or the expansion module is incorrectly installed.
Figure 6-114 Indicators on an expansion module
OceanStor V5 Series
Parts Replacement 6 Replacing CRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 120
To Next Page
Loading...
