Huawei OceanStor V5 Series

To Next Page

To Previous Page

Procedure

Step 1 Run SmartKit.

Step 2 Choose Home > Storage > Routine Maintenance > Health Check.

● OceanStor SmartKit users are grouped into Huawei engineers, Channel partner

engineers, Customers, and Visitors based on user permissions. You can log in to the

Inspection tool using one of the preceding roles.

● Visitors users do not have corresponding accounts. When you log in to OceanStor

SmartKit, on the tool activation page that is displayed, select Not activate and go to

the SmartKit GUI. Then you can use the tool as a Visitor.

● If you log in to OceanStor SmartKit as a Visitor, you have only 15 days for trial use. You

cannot use the tool after the trial period expires.

● The following uses Huawei engineers as an example.

Step 3 On the Health Check page, perform a health check in the sequence of Device

Selection, Inspection, Information Collection, and then Disk Health Analysis, as

shown in Figure 7-1.

Figure 7-1 Health check sequence

Step 4 Click Device Selection. The Select Devices page is displayed, as shown in Figure

7-2.

Figure 7-2 Selecting devices

OceanStor V5 Series

Parts Replacement 7 Replacing FRUs

Huawei OceanStor V5 Series - Page 146