Step 6 Put the removed interface module into an ESD bag.
Step 7 Take the spare part out of its ESD bag.
Step 8 Insert the spare part into the empty slot until it clicks into place, as shown in
Figure 7-81.
Figure 7-81 Installing an interface module
This gure uses a 2 U controller enclosure as an example. The method used to replacing an
interface module for a 3 U or 6 U controller enclosure is the same as that for a 2 U
controller enclosure.
Step 9 Connect the cables.
After the interface module is installed, you are advised to wait four minutes before
connecting the cables so that the status of the new interface module can be
updated.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 228
To Next Page
Loading...
