Huawei OceanStor V5 Series

To Next Page

To Previous Page

Tools and Materials

● ESD wrist strap

● ESD bag

● Labels

Procedure

Step 1 Check system status before replacement.

1. Check system status.

Start SmartKit and choose Home > Storage > Routine Maintenance >

Health Check. On the Health Check page, perform inspection as instructed.

For details, see 7.1.2 Checking System Status.

If any items fail the inspection, rectify the faults by performing the recommended

actions in the inspection reports. Ensure that all other parts except the parts to be

replaced are working properly.

2. Check the status of the parts to be replaced.

Start SmartKit and choose Home > Storage > Parts Replacement > Parts

Replacement. On the Parts Replacement page, click FRU Replacement.

Then complete the check before the replacement as prompted. For details, see

7.1.3 Replacing an FRU.

NO TICE

You can proceed to next steps only when all items pass the pre-replacement check

and the replacement page is displayed. If any item fails, rectify the fault as

prompted.

Step 2 Wear an ESD wrist strap.

Step 3 Optional: Check the status of the Power indicator/Hot Swap button on the 8

Gbit/s Fibre Channel interface module (eight ports) to determine whether the

interface module has been successfully powered

o, as shown in Figure 7-83.

● If the indicator is o, the interface module has been successfully powered o.

Proceed to Step 4.

● If the indicator is on, use a paper clip or a similar object to press the Power

indicator/Hot swap button on the 8 Gbit/s Fibre Channel interface module

(eight ports) to power

o the interface module.

Figure 7-83 Power indicator/Hot Swap button on an 8 Gbit/s Fibre Channel

interface module (eight ports)

OceanStor V5 Series

Parts Replacement 7 Replacing FRUs

Huawei OceanStor V5 Series - Page 240