Figure 7-87 Power indicator/Hot Swap button on an 8 Gbit/s Fibre Channel
interface module (eight ports)
Step 11
When the Power indicator becomes steady green, install the optical module.
Take the dustproof cap o the optical module, hold the rubber handle outside the
optical module, and insert the optical module into the port, as shown in Figure
7-88.
● Push the optical module to the end. If you hear the click or feel a weak
vibration, the optical module has been successfully installed.
● If an optical module is installed incorrectly, it will be loose or cause a link
interruption.
Figure 7-88 Installing an optical module
Step 12 Connect cables.
The cable should be connected to the new 8 Gbit/s Fibre Channel interface
module (eight ports) at the same position as to the old one to ensure proper
service running.
After the 8 Gbit/s Fibre Channel interface module (eight ports) is installed, wait 4 minutes
before connecting the cables so that the status of the new module can be updated.
OceanStor V5 Series
Parts Replacement 7 Replacing FRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 235
To Next Page
Loading...
