Step 6 Take the spare part out of its ESD bag.
Step 7 Open the handle of the spare part, insert the spare part into the empty slot, and
close the handle, as shown in Figure 6-18.
The procedure for installing a DC power module is the same as that for installing an AC
power module. This step uses the AC power module as an example.
Figure 6-18 Installing an AC power module
Step 8 Insert the power cables.
● Secure the AC power cables with retention clips.
1. Press the locker of the retention clip outwards (as shown in a of step 1 in
Figure 6-19), and meanwhile slide the retention clip to the connection part of
the AC power cable (as shown in b of step 1 in Figure 6-19).
Figure 6-19 Securing the AC power cables with retention clips
OceanStor V5 Series
Parts Replacement 6 Replacing CRUs
Issue 15 (2019-12-30) Copyright © Huawei Technologies Co., Ltd. 35
To Next Page
Loading...
