Huawei RH2288 V3 - Setting the Management Network Port IP Address

Step 2 Choose Config > Security Enhance.
Step 3 Select Enable for Password Complexity Check.
The system will perform a password complexity check when a new password is set.
Step 4 Choose Config > Local User, as shown in Figure 5-16.
Figure 5-16 Local User page
Step 5 Click next to the user whose password needs to be changed.
Step 6 Change the password as prompted.
l When the password complexity check function is disabled, the password can be empty or
a string of any characters fewer than 20 characters.
l When the password complexity check function is enabled, the password must meet the
following requirements:
– Must contain 8 to 20 characters.
– Must contain at least one space or one of the following special characters:
`~!@#$%^&*()-_=+\|[{}];:'",<.>/?
– Must contain at least two types of the following characters:
n Uppercase letters
n Lowercase letters
n Digits
– Must not be the same as the user name or the reverse of the user name.
----End
5.7 Setting the Management Network Port IP Address
Set the management network IP address through the iBMC WebUI and BIOS. You can also
set the IP address by running the ipaddr command on the iBMC CLI. For details, see the
Huawei Rack Server iBMC User Guide.
Table 5-5 lists the default data for setting the management network IP address.
RH2288 V3 Server
User Guide
5 Configuring the RH2288 V3
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 117