Figure 3-14 CMA cabling
Step 6 Power on the RH2288 V3.
----End
3.5 Connecting External Cables
This section describes how to connect cables to the server.
3.5.1 Connecting Cables to a Mouse, Keyboard, and VGA Port
After powering on the server, connect cables to a mouse, keyboard, and VGA port to set the
BIOS and RAID, and log in to the OS.
The front and rear panels of the server provide DB15 VGA ports but have no standard PS/2
port for a keyboard or mouse. You can connect a keyboard and mouse to the USB ports on the
front or rear panel based on site installation conditions. The following describes two
connection methods:
l Connect a keyboard and mouse to the USB ports.
l Connect a keyboard and mouse using a USB-to-PS/2 cable.
Procedure
Step 1 Connect the USB connector on the PS/2 cable to the USB port on the front or rear panel of the
server.
RH2288 V3 Server
User Guide
3 Installing and Removing the Server
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 77
To Next Page
Loading...
