Step 9 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 10 Install the RH2288 V3. For details, see 3.4 Installing the Server.
Step 11 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 12 Power on the RH2288 V3. For details, see 4.1 Powering On the Server.
----End
7.36 Installing the Supercapacitor (PCIe Plug-in RAID
Controller Card)
A supercapacitor is configured to provide power-off protection for an LSI SAS3108 or
PM8060 PCIe plug-in RAID controller card.
Install a supercapacitor to replace the one that has failed or cannot provide sufficient power.
Before installing a supercapacitor, power off the server and observe electrical safety
precautions.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Remove the supercapacitor to be replaced. For details, see 7.34 Removing the
Supercapacitor (PCIe Plug-in RAID Controller Card).
Step 3 Take the supercapacitor out of its ESD bag.
Step 4 Place the supercapacitor downwards and exert even force to install it in the tray. Ensure that
the supercapacitor is secured by the plastic latches. See step (1) in Figure 7-68 and Figure
7-69.
Step 5 Determine the position and chip model of the RAID controller card connected to the
supercapacitor to be installed.
l If the chip model of the RAID controller card is LSI SAS3108, install the trans flash
module (TFM) first.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 191
To Next Page
Loading...
