Figure 7-26 Installing the supercapacitor tray
Step 6 Install full-height full-length riser cards if they are required. For details, see 7.20 Installing a
Riser Card.
Step 7 Install the chassis cover. For details, see 7.12 Installing the Chassis Cover.
Step 8 Install the RH2288 V3. For details, see 3.4 Installing the Server.
Step 9 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 10 Power on the RH2288 V3. For details, see 4.1 Powering On the Server.
----End
7.15 Removing a Fan Module
Remove a fan module before replacing it with a new one or removing other components (such
as the mainboard and DVD drive).
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
NOTE
The fan modules are hot-swappable. You can skip steps Step 3 to Step 5 when you can open the chassis
cover without removing the server. The scenarios include but are not limited to: (1) the server is installed
on holding or adjustable guide rails and (2) the server is not installed in a cabinet.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 152
To Next Page
Loading...
