7.29 Removing the Screw-in RAID Controller Card
Remove a screw-in RAID controller card before replacing it with a new one. The appearance
and position of a screw-in RAID controller card may vary according to models, but the
removal method is the same.
Procedure
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server to be removed, and label its
panel to prevent misoperations.
Step 3 Power off the RH2288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the RH2288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove full-height full-length riser cards if they are installed. For details, see 7.19 Removing
the Riser Card.
Step 8 Remove the supercapacitor if it is installed. For details, see 7.33 Removing the
Supercapacitor (Screw-in RAID Controller Card).
Step 9 Determine the position of the RAID controller card. See Figure 7-58.
Figure 7-58 Position of the RAID controller card
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 180
To Next Page
Loading...
