Step 9 Install the RH2288 V3. For details, see 3.4 Installing the Server.
Step 10 Connect all external cables such as power and network cables. For details, see 3.5
Connecting External Cables.
Step 11 Power on the RH2288 V3. For details, see 4.1 Powering On the Server.
----End
7.55 Removing the VGA Board
Remove the video graphics array (VGA) board if it has failed.
Server with Eight 3.5-inch Hard Disks
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its panel to prevent
misoperations.
Step 3 Power off the RH2288 V3. For details, see 4.2 Powering Off the Server.
Step 4 Remove all external cables such as power and network cables.
Step 5 Remove the RH2288 V3 and put it on an ESD desktop. For details, see 3.6 Removing the
Server.
Step 6 Remove the chassis cover. For details, see 7.11 Removing the Chassis Cover.
Step 7 Remove the air duct. For details, see 7.13 Removing the Air Duct.
Step 8 Remove all fan modules. For details, see 7.15 Removing a Fan Module.
Step 9 Press and hold down the latches on both sides of a fan module bracket, and lift the bracket.
Use the same method to lift the other fan module bracket. See steps (1) and (2) in Figure
7-125.
Figure 7-125 Removing fan module brackets
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 241
To Next Page
Loading...
