Step 10 Locate the cables connecting the mainboard and the front disk backplane to the DVD-ROM
drive and the VGA board, and disconnect the cables from the mainboard and the front disk
backplane. For details, see 2.7 Internal Cabling.
Step 11 Loosen and remove the screws on the server. See step (1) in Figure 7-126.
Figure 7-126 Removing the VGA board from a server with eight 3.5-inch hard disks
Step 12
Push the panel out of the server. See step (2) in Figure 7-126.
Step 13 Remove all cables connected to the VGA board.
Step 14 Loosen the screws on the VGA board. See step (3) in Figure 7-126.
Step 15 Remove the VGA board in the arrow direction. See step (4) in Figure 7-126.
Step 16 Place the removed VGA board in an ESD bag.
----End
Server with Eight 2.5-inch Hard Disks
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Determine the cabinet number and chassis number of the server, and label its panel to prevent
misoperations.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 242
To Next Page
Loading...
