7.24 Installing the DVD Drive
Install a DVD drive to replace the original one.
With Eight 2.5-inch Hard Disks
Step 1 Wear an ESD wrist strap. For details, see 1 Safety Instructions.
Step 2 Remove the DVD drive to be replaced. For details, see 7.23 Removing the DVD Drive.
Step 3 Take the spare DVD drive out of its ESD bag.
Step 4 Tighten two M2 flat-head screws using the Phillips screwdriver to secure the plastic latch to
the DVD drive. See step (1) in Figure 7-49.
Figure 7-49 Installing the DVD drive on a server with eight 2.5-inch hard disks
Step 5 Insert the DVD drive into the support. See step (2) in Figure 7-49.
Step 6 Connect cables to the DVD drive. See step (3) in Figure 7-49.
NOTE
If fan modules have been installed, remove them and the fan support before connecting cables.
RH2288 V3 Server
User Guide
7 Replacing Parts
Issue 32 (2019-03-28) Copyright © Huawei Technologies Co., Ltd. 172
To Next Page
Loading...
