Huawei UPS2000-G Series - Page 78

Figure 4-29 Output screen
NO TE
The UPS supports 208 V output. In the case of 208 V output, the power is derated to
90%. The cable connections and cable connections for 208 V and 200 V are similar.
Table 4-19 Output settings
Item Description Default Value Value Range
Output
mode
Set the system output
mode. The input mode is
identied automatically
by the system. This
parameter is
congurable only after
the inverter is shut
down.
This
parameter is
not
congurable
for the 6
kVA/10 kVA
models. The
default value
is Single-
phase.
15 kVA/20
kVA: Three-
phase
Single–phase,
Three-phase
Voltage
level
Indicates the system
output voltage level.
After you change the
voltage level, the upper
threshold for bypass
voltage is restored to the
default value (15% or
20%). This parameter is
congurable only after
the inverter is shut
down.
6 kVA/10 kVA:
220 V
15 kVA/20
kVA single-
phase output:
220 V
15 kVA/20
kVA three-
phase output:
380 V
6 kVA/10 kVA:
208 V, 220 V, 230
V, 240 V
15 kVA/20 kVA
single-phase
output: 208 V, 220
V, 230 V, 240 V
15 kVA/20 kVA
three-phase
output: 380 V, 400
V, 415 V
UPS2000-G-(6 kVA-20 kVA)
User Manual 4 Control Panel
Issue 21 (2022-10-13) Copyright © Huawei Technologies Co., Ltd. 70