USG9520's Device status:
Slot # type online register status primary
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
1 LPU Present Registered Normal NA
6 SPU Present Registered Normal NA
8 LPU Present Registered Normal NA
9 MPU Present NA Normal Master
10 MPU Present Registered Normal Slave
11 SFU Present Registered Normal NA
12 SFU Present Registered Normal NA
13 SFU Present Registered Normal NA
14 SFU Present Registered Normal NA
15 CLK Present Registered Normal Master
16 CLK Present Registered Normal Slave
17 PWR Present Registered Normal NA
18 PWR Present Registered Normal NA
19 FAN Present Registered Normal NA
When Unregistered is displayed in the Register column, it indicates that the board in the slot
fails to be registered. When Abnormal is displayed in the Status column, it indicates that the
board in the slot is running abnormally.
NOTE
If NA is displayed in the Register field, the board is a master MPU.
When the board in a certain slot cannot be registered or runs abnormally, record the board
status and contact technical support personnel to check whether the device can be upgraded or
the board needs to be replaced. After the upgrade, check the status of the board. If the board
cannot run normally still, contact technical support personnel.
Checking Session Statistics
In any view, run the display firewall session statistics command to check session statistics.
You need to record the session statistics before and after upgrade for comparison. This will
help you check whether the services of the device are normal after upgrade.
<USG9500> display firewall session statistics
Session Statistics:
Slot 6 cpu 0: 0
Slot 6 cpu 1: 0
Slot 6 cpu 2: 0
Slot 6 cpu 3: 0
Total 0 session(s) on all slots.
Session Creation Rate(num/s):
Slot 6 cpu 0: 0
Slot 6 cpu 1: 0
Slot 6 cpu 2: 0
Slot 6 cpu 3: 0
Total session(s) creation rate on all slots is 0.
Checking Traffic Statistics
In any view, run the display interface interface-type interface-number command to check the
traffic statistics on a service interface. You need to record the traffic statistics before and after
upgrade for comparison. This will help you check whether the services of the device are
normal after upgrade.
The following is sample output from this command on GigabitEthernet 1/0/2:
<USG9500> display interface GigabitEthernet 1/0/2
GigabitEthernet1/0/2 current state : UP
Line protocol current state : UP
Description: test
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
138
To Next Page
Loading...
