Huawei USG6000 - Checking the Running Status of the Device

IPS Update : Enabled; service expire time: 2023/04/24
Anti Virus Update : Enabled; service expire time: 2023/04/24
2.2.6.4 Checking the Running Status of the Device
Checking the CPU and Memory Usage
In any view, run the display health command to check the CPU and memory usage. If the
CPU and memory usage before and after upgrade differs slightly, it indicates that the device is
running normally.
<USG9500> display health
Slot CPU Usage Memory Usage(Used/Total) Simulate CPU
-----------------------------------------------------------------------
4 MPU(Master) 7% 45% 772MB/1714MB None
1 LPU 15% 35% 293MB/820MB None
2 SPU-CPU1 82% 17% 85MB/500MB 0%
2 SPU-CPU3 80% 17% 85MB/500MB 0%
2 SPU-CPU6 2% 14% 57MB/398MB None
Checking Session Statistics
In any view, run the display firewall session statistics command to check session statistics. If
the session statistics before and after upgrade differ slightly, it indicates that services are
running normally.
<USG9500> display firewall session statistics
Session Statistics:
Slot 6 cpu 0: 0
Slot 6 cpu 1: 0
Slot 6 cpu 2: 0
Slot 6 cpu 3: 0
Total 0 session(s) on all slots.
Checking Traffic Statistics
In any view, run the display interface interface-type interface-number command to check the
traffic statistics on a service interface. If the traffic statistics before and after upgrade differ
slightly, it indicates that services are running normally.
The following is sample output from this command on GigabitEthernet 1/0/2:
<USG9500> display interface GigabitEthernet 1/0/2
GigabitEthernet1/0/2 current state : UP
Line protocol current state : UP
Description:Huawei, FW Series, GigabitEthernet1/1/1 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 101.1.1.2/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-8239-1e5c
The Vendor PN is PLRXPL-VI-S24-HW
The Vendor SN is CE10QQ8VK
The Vendor Name is JDSU
Port BW: 1G, Transceiver max BW: 1G, Transceiver Mode:
MultiMode
Rx Power: -5.50dBm, Warning range: [-16.99, 0.00]dBm
Tx Power: -4.97dBm, Warning range: [-9.50, 0.00]dBm
Loopback:none, full-duplex mode, negotiation: disable, Pause Flowcontrol:Receive
Enable and Send Enable
Last physical up time : 2016-01-28 14:12:56 UTC+08:00
Last physical down time : 2016-01-28 13:56:19 UTC+08:00
Max input bit rate: 837731200 bits/sec at 2016-01-28 19:28:32
Max output bit rate: 96 bits/sec at 2016-01-28 14:23:09
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
165