Huawei USG6000 - Upgrade Result Verification

install-module URLRMT_H50010000_yyy.mod next-startup
After the configuration is complete, run the display module-information verbose command
to view details on the dynamically loaded component package. The following information is a
part of the command output. If the State value is INSTALL_OK, the component package has
been successfully loaded.
<sysname> display module-information verbose
Module Information
------------------------------------------------------------------------
Module Version InstallTime PackageName
------------------------------------------------------------------------
ConSecGroup 1.0.0.0 2015-12-23 11:13:37+00:00 CSG_H50010000_yyy.mod
URL Filter 1.0.0.0 2015-12-23 11:13:37+00:00 URLRMT_H50010000_yyy.mod
************************************************************************
* Content Security Group information, as follows: *
************************************************************************
Slot Type State Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
************************************************************************
* URL Filter information , as follows: *
************************************************************************
Slot Type State Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
…………………
Step 11 Restart the NGFW.
NOTICE
l If the configuration file for the next startup is imported, restart the device without saving
the running configuration. Otherwise, the running configuration will overwrite the
imported configuration.
l For the upgrade from V500R001 to V500R001C80SPC100, if the configuration file is not
imported, you are advised to save the current configurations before restarting the device.
<FW> reboot fast
Now, the upgrade to V500R001C80SPC100 is complete. The optional follow-up task is to
restore and test services.
----End
1.3.5.3 Upgrade Result Verification
Checking the Information About the Current Version Software
After the device is started, log in to the CLI. In any view, run the display version command to
check the information about the running version software. The following is a sample output
for this command.
<sysname> display version
Huawei Versatile Routing Platform Software
VRP (R) Software, Version 5.160 (USG6620V500R001C80SPC100)
HUAWEI USG6000&USG9500
Upgrade Guide
1 USG6000
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
68