start read file....
Succeeded in setting the software for booting system.
Step 7 In the user view, run the startup saved-configuration filename command to specify the
configuration file for the next startup of the NGFW as the uploaded file.
<NGFW> startup saved-configuration vrpcfg_new.cfg
Info: Succeeded in setting the configuration for booting system.
Step 8 (Optional) Upload and activate a new license file if required. Skip this step if no new license
file is required.
Run the put command to upload the new license file (for example, license_new.dat) to the CF
card of the NGFW. The name of the file to be uploaded cannot be the same as the name of any
existing file in the CF card. If a file with the same name already exists in the CF card, the file
is replaced by the uploaded file.
Run the license active file filename command in the system view to activate the license file.
[NGFW] license active license_new.dat
Info:License is successfully activated.
Step 9 (Optional) Update the signature databases of security functions.
Before upgrading the signature database, ensure that the activated license file contains the
content security function.
If the latest signature databases are not required, skip this step. The NGFW will automatically
load the default signature databases after startup.
If the latest signature database is required, you can upgrade the signature database in either
the online or local upgrade mode. For details, see the chapter "Upgrade Center " in the
HUAWEI USG6000&USG9500 V500R001C80SPC100 V500R001C80SPC100 Product
Documentation.
Step 10 (Optional) Upgrade Content Security Features.
Run the put command to upload the content security feature component package (such as
CSG_H50010000_yyy.mod or URLRMT_H50010000_yyy.mod) of V500R001C80SPC100
to the $_install_mod folder in the CF card of the USG6000. The name of the file to be
uploaded cannot be the same as the name of any existing file in the CF card. If a file with the
same name already exists in the CF card, the file is replaced by the uploaded file.
NOTICE
l If no content security feature is involved, skip this step.
l Ensure that an activated license file is available. If the license file is not activated, the
upgrade fails.
l You must obtain the component package from the security center (http://sec.huawei.com)
in advance and upload it to the $_install_mod folder in the root directory. Then, load the
component package as follows:
Upgrading the content security feature component package applies to the following
scenarios:
l Upgrading V500R001 to V500R001C80SPC100.
install-module CSG_H50010000_yyy.mod next-startup
HUAWEI USG6000&USG9500
Upgrade Guide
1 USG6000
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
67
To Next Page
Loading...
