Run the put command to upload the content security feature component package (such as
CSG_H50010000_xxx.mod or URLRMT_H50010000_xxx.mod) of V500R001C80SPC100
to the $_install_mod folder in the CF card of the USG6000. The name of the file to be
uploaded cannot be the same as the name of any existing file in the CF card. If a file with the
same name already exists in the CF card, the file is replaced by the uploaded file.
NOTICE
l If no content security feature is involved, skip this step.
l Ensure that an activated license file is available. If the license file is not activated, the
upgrade fails.
l You must obtain the component package from the security center (http://sec.huawei.com)
in advance and upload it to the $_install_mod folder in the root directory. Then, load the
component package as follows:
Upgrade package:
l Upgrading V500R001 to V500R001C80SPC100.
– Content security component package
install-module CSG_H50010000_yyy.mod next-startup
– URL component package
install-module URLRMT_H50010000_yyy.mod next-startup
– Cloud sandbox component package
install-module CSB_H50010000_yyy.mod next-startup
After the configuration is complete, run the display module-information verbose command
to view details on the dynamically loaded component package. The following information is a
part of the command output. If the State value is INSTALL_OK, the component package has
been successfully loaded.
<USG9500> display module-information verbose
Module Information
------------------------------------------------------------------------
Module Version InstallTime PackageName
------------------------------------------------------------------------
ConSecGroup 1.0.0.0 2015-12-23 11:13:37+00:00 CSG_H50010000_yyy.mod
URL Filter 1.0.0.0 2015-12-23 11:13:37+00:00 URLRMT_H50010000_yyy.mod
************************************************************************
* Content Security Group information, as follows: *
************************************************************************
Slot Type State Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
************************************************************************
* URL Filter information , as follows: *
************************************************************************
Slot Type State Detail
------------------------------------------------------------------------
- NP INSTALL_OK -
…………………
Step 15 Run the reboot command to restart the USG9500.
HUAWEI USG6000&USG9500
Upgrade Guide
2 USG9500
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
146
To Next Page
Loading...
