Huawei USG6000 - Page 16

The command Description Impact
[ undo ] web-manager
security verify-ssl-peer
The command disables
bidirectional certificate
authentication between the
FW and client.
None
[ undo ] web-manager
security ca-certificate ca-
certificate-name
The command enables/
disables bidirectional
certificate authentication
between the FW and client.
None
[ undo ] banner enable The command enables/
disables the display of the
system banner.
None
[ undo ] mac-access-profile
access-profile-name
The command binds/
unbinds an authentication
profile to a MAC access
profile
None
hwtacacs-server accounting
ip-address [ port ] [ vpn-
instance vpn-instance-
name ] [ secondary | third ]
The command configures an
HWTACACS accounting
server.
None
ldap-server source
{ loopback interface-
number | ip-address ip-
address | vlanif interface-
number }
The command configures
the source IP address that a
device uses when sending
packets to the LDAP server.
None
undo ldap-server source The command restores the
default configuration. By
default, when a device sends
packets to the LDAP server,
the IP address of the actual
outbound interface is used
as the source IP address.
None
ad-server source { loopback
interface-number | ip-
address ip-address | vlanif
interface-number }
The command configures
the source IP address that a
device uses when sending
packets to the AD server.
None
display ike sa [ remote
{ ipv4-address | ipv6-
address } ] [ slot slot-id cpu
cpu-id ] [ active | standby ]
The command displays
information about SAs
established through IKE
negotiation.
None
display ike sa [ slot slot-id
cpu cpu-id ] [ active |
standby ] [ remote-id-type
remote-id-type ] remote-id
remote-id
The command displays
information about SAs
established through IKE
negotiation.
None
HUAWEI USG6000&USG9500
Upgrade Guide
1 USG6000
Issue 01 (2018-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7