Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 82 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Playback—the playback behavior:
• Play Once—plays the message one time.
• Repeat—plays the message the number of times specified by play count.
• Continuous—plays the message until the event is cancelled.
Pre-Tone—pre-announcement tone for the live audio broadcast. These tones are accessible through the
PLAYBACK AUDIO, SYSTEM TONES screen (see the System Tones section).
Post-Tone—the post-announcement tone for the live audio broadcast. These tones are accessible through
the PLAYBACK AUDIO, SYSTEM TONES screen (see the System Tones section).
External Event Options
Figure 87. External Event Options
Source Specific ?—selected and disabled because all external audio sources need an input contact to
trigger the source since they do not have PTT buttons.
Source—available sources are enabled in the LIVE AUDIO SOURCES, LIVE AUDIO CONFIGURATION panel
(on page 60).
Event Cancel
Specifies how the system cancels events:
Require Cancel—requires cancelling the event from an access panel button before the system can clear
it.
Cancel Mode:
• Manual— an access panel must cancel the event.
• Auto—cancel the event manually or it will cancel automatically after the Auto-Cancel Delay expires.
• Auto-Cancel Delay—delay (seconds) for the event to cancel.
Event Acknowledge
Ack Required—an access panel must acknowledge the event before it clears.
Mute on Ack—event audio mutes when the event is acknowledged for the Max Mute Duration as
specified on the GLOBALS panel on the SYSTEM PROPERTIES screen.
ACK MODE:
Manual—an access panel must acknowledge the event.
To Next Page
Loading...
Need help?
General
