INSTALLATION
9
Attach the Universal Cord Tensioner — EasyRise
™
Shades Only
Before you proceed, you must first slide the cord tensioner(s) to the bottom of the cordloop.
■ Insert a small screwdriver, punch, or awl through the screw hole at the bottom
of the cord tensioner.
■ Move the screw hole down to the indicator line to release the safety
mechanism.
■ Slide the cord tensioner down to the bottom of the cordloop.
■ Attach the cord tensioner(s) according to the instructions
provided with the Universal Cord Tensioner Installation Kit.
WARNING: It is imperative that the cord tensioner(s) be properly secured to
the wall or window frame to reduce children’s access to the cord loop.
Young children can strangle in cord loops. They can also wrap cords around
their necks and strangle.
CAUTION: The shade will not operate properly unless the cord tensioner(s)
is secured. A Universal Cord Tensioner Installation Kit has been included
with your shade. Follow the instructions in the kit to correctly secure the
cordtensioner(s).
Cord Adjustment — UltraGlide
®
Shades Only
Adjusting the tassel to eye level will decrease the amount of pulls needed to raise and lower
theshade. This will also enhance child and pet safety.
To Shorten the Tassel Cord
■ Grasp both parts of the tassel (the colored cover and the
frosted body).
■ Squeeze the tassel cover with your thumb and forefinger
(at the “s” in the HunterDouglas logo).
■ Separate and slide the tassel cover off from the tassel body.
■ Pull out the knotted end of the tasselcord.
■ Tie the cord at the desired shorter length using a double knot.
■ Trim the tassel cord below the knot.
■ Pull the trimmed knot up inside the tassel.
■ Squeeze the tassel cover while sliding it back onto the tassel body.
IMPORTANT: After reassembling, be sure there are no gaps between the two components.
Check that they do not pull apart easily. The tassel cover should be securely seated into the
tassel body.
Tassel
Cover
Tassel
Cord
Tassel
Body
To Next Page
Loading...
Need help?
General
