CARE
15
Removing the Shade
■ While holding the headrail, lower the shade
approximately 4".
■ Push back on the bottom tab of the installation
bracket using your thumb or a flat blade
screwdriver to release the bottom edge of
theheadrail.
■ After releasing the bottom edge, roll the back of the
headrail down and out from the bracket.
Cleaning Procedures
Vignette
®
Modern Roman Shades are made of an anti-static, dust-resistant fabric which repels
dirt and dust. For most fabrics, the options below are available if your shade needs cleaning.
Dusting
■ Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
■ Use a hand-held vacuum with low suction for more thorough dust removal.
Compressed Air / Hair Dryer (Cool Setting)
■ Blow dirt and debris from within the fabric folds using clean, compressed air.
Spot-Cleaning
■ Prepare a solution of warm water and mild detergent.
■ Dampen a clean cloth in the solution and wring it out.
■ Place a dry, clean cloth behind the spot between the face fabric and the back fabric.
■ Dab the spot with the dampened cloth until it is removed. Non-oil-based baby wipes may be
used on more stubborn stains. Do not rub the fabric.
■ Allow the shade to dry in the completely lowered position.
Back of
Shade
Push back against
the tab using
your thumb or flat
blade screwdriver.
Roll the headrail
down and out
from the bracket.
Tab
➊
➋
To Next Page
Loading...
Need help?
General
