Hunter Douglas Vignette Series User Manual

CARE
23
Removing the Shade (If Necessary)
Remove the Fabric Panel(s) (Outside Mount Only)
■ Unscrew and remove the end caps.
■ Loosen and remove all cord anchors from the front channel of the headrail.
■ Slide the panel(s) out of the headrail.
Remove the Headrail
■ Open the shade if the fabric is still installed.
■ While holding the headrail, push back on the bottom
tab of each installation bracket using a small flat
blade screwdriver. This releases the bottom edge
of the headrail.
■ Rotate the back of the headrail down and out from
the brackets.
Cleaning Procedures
Hunter Douglas Vignette
®
Modern Roman Shades are made of an anti-static, dust-resistant
fabric that repels dirt and dust. For most fabrics, the following cleaning options are available.
Dusting
■ Regular light dusting with a feather duster is all the cleaning needed in most circumstances.
Vacuuming
■ Use a hand-held vacuum with low suction for more thorough dust removal.
Compressed Air / Hair Dryer (Cool Setting)
■ Blow dirt and debris from within the fabric folds using clean, compressed air.
Spot-Cleaning
■ Prepare a solution of warm water and mild detergent.
■ Dampen a clean cloth in the solution and wring it out.
■ Place a dry, clean cloth behind the spot between the face fabric and the back fabric.
■ Dab the spot with the dampened cloth until it is removed. Non-oil based baby wipes may be
used on stubborn stains. Do not rub the fabric.
■ Allow the shade to dry in the completely closed position.
Flat Blade
Screwdriver

Hunter Douglas Vignette Series Specifications

General

Series	Vignette
Operation	Manual or motorized
Fabric Options	Variety of colors and textures
Material	Fabric
UV Protection	Yes
Energy Efficiency	Yes (insulating properties vary by fabric)