Hunter Douglas Vignette Series User Manual

INSTALLATION
10
Attach the Magnetic Hold-Down Brackets (Optional)
■ Lower the shade until it is fully lowered.
■ Attach the magnetic hold-down bracket onto the bottom rail just
inside the end cap, oriented as shown.
■ Mark the screw location using one of the mounting options shown
below.
➤ The screw should be placed in the middle of the channel. This
will allow for adjustment.
■ Drill the screw holes using a
3
/ 32 " drill bit.
CAUTION: Use drywall anchors when mounting into drywall.
■ Attach the hold-down brackets to the mounting surface using
the screws provided.
■ If necessary, adjust the bracket height by loosening the screw and
sliding the bracket up or down.
Hold-Down
Bracket
End
Cap
Outside Mount
Preferred Alternate
Inside Mount
Preferred Alternate
Adjust the
bracket
using the
channel.

Hunter Douglas Vignette Series Specifications

General

Series	Vignette
Operation	Manual or motorized
Fabric Options	Variety of colors and textures
Material	Fabric
UV Protection	Yes
Energy Efficiency	Yes (insulating properties vary by fabric)