When the HD Elite performs a spin with the load
roller enabled, it measures the road force of the wheel
assembly. ForceMatch® is enabled on every Road
Force® spin.
NOTICE
It is important that the air pressure of the
tire is set to specications prior to using
the Road Force Measurement® system.
Incorrect tire pressure will aect the results.
ForceMatch® - Display of Data
Press ForceMatch® in the RoadForce menu and after
the assembly has been spun, the ForceMatch data will
display on screen.
The upper left corner of the screen displays Road Force®
and runout data. A 3D display of the assembly is shown,
with corresponding “chalk marks” on both the tire and
rim.
Matching the chalk marks will produce the minimum
available Road Force® in the assembly
Buttons on the right allow the operator to return to the main balance screen, view details and plots, and change the data
being viewed.
Touching “Show After ForceMatching” will change the 3D
scene (matching up the chalk marks and showing the
resulting Road Force® change in the color spectrum on
the tire) as well as show the predicted resultant assembly
force and diagnosis (upper left data).
Forcematching® - No Runout
If the operator accesses Forcematching® without the
required data having been measured, the screen will
prompt the operator. A 180 match will need to be done if
this happens.
Forcematching® - Show After Prediction
Touching the “Show After ForceMatching” button will
change the 3D scene (matching up the chalk marks and
showing the resulting Road Force® change in the color
spectrum on the tire) as well as show the predicted
resultant assembly force and diagnosis (upper left data).
ForceMatch® Procedures
HD Elite Wheel Balancer
Page 40 of 51
To Next Page
Loading...
