Why does my Hunter XC Hybrid display read 'Off'?
If your Hunter Controller display reads “Off,” it means the rain sensor is interrupting irrigation or the sensor jumper has been removed. You can slide the rain sensor bypass switch to the BYPASS position to bypass the rain sensor circuit, or reinstall the jumper.
What to do if the display shows a station is running, but the icons are flashing on my Hunter XC Hybrid Controller?
If your Hunter Controller is showing that a station is running, but the and icons are flashing, it means the sensor is interrupting irrigation, but the station has been set to override the sensor. You should check the Programmable Sensor Override status.
What to do if my Hunter Irrigation System display shows 'BATT'?
If your Hunter Irrigation System displays 'BATT', the batteries are low. Replace the batteries.
How to fix no display on Hunter XC Hybrid?
If there is no display on your Hunter Controller, check the batteries or AC power and correct any errors.
What to do if the rain sensor won't shut off my Hunter XC Hybrid system?
If the rain sensor will not shut off the system on your Hunter Controller, it could be due to a defective rain sensor, the jumper was not removed when the sensor was installed, or stations have been programmed to override the sensor. Verify the operation of the rain sensor and proper wiring. Remove the jumper from the sensor terminals. Reprogram the sensor override to enable the sensor.
How to fix a frozen display on a Hunter Controller?
If your Hunter Controller has a frozen display or is showing incorrect information, it is likely due to a power surge. You can reset the controller.
What to do if Hunter Irrigation System display shows P 'ERR'?
If your Hunter Irrigation System display shows P 'ERR', there is likely a short in the P/MV wiring or solenoid. Check the wiring and solenoid at the Master Valve, and verify the specifications for the Pump Start Relay.
General| Voltage | 24 VAC |
|---|---|
| Display | LCD |
| Start Times per Program | 4 start times per program |
| Enclosure | Weather-resistant |
| Cycle and Soak | Yes |
| Manual Watering | Yes |
| Zones | Up to 8 |
| Battery Backup | Yes |
| Weather Adjustment | Yes |
Details the controller's LCD display, wiring compartment, and control buttons.
Explains the controller dial positions and the optional external transformer connection.
Guides on securely mounting the controller unit to a wall surface.
Details the process of wiring irrigation valves and notes DC solenoid requirements.
Guides connecting, testing, and bypassing the weather sensor for optimal performance.
Guides setting the controller's date, time, and program start times.
Details setting station run times and selecting specific watering days.
Explains odd/even days, interval watering, and setting specific days off.
Covers enabling automatic watering, system off, and programmable rain delays.
Describes manual station watering, all-station watering, and one-touch start.
Allows custom sensor control for individual watering stations.
Covers saving/retrieving programs, test cycles, and inter-station delays.
Details digging the hole, mixing cement, and securing the mounting plate to the pole.
Guides routing wires, attaching the controller to the mounting plate, and securing it.
Details technical specifications for operation and electrical requirements.
Defines symbols used on the controller and in the manual.
To Next Page
