H.32 Part. N. 8000 H0368 (09-2008)
ENGINE REASSEMBLY
*: "d" cut posistion
Fit the piston rings as shown in the picture. The manufacturer mark, if it is present
on the piston ring, must be turned upwards.
Assembly of piston and cylinder
Install a new base gasket. Install the piston, lubricate the piston with motor oil and
install the piston pin circlips. Make sure that the arrow on the piston is pointing
forward.
Lubricate the cylinder liner with engine oil and push it down over the piston rings.
PISTON RING CUT SETTING
PISTON RING CUT SETTING
PISTON RING CUT SETTING
To Next Page
Loading...
