• Fix the rebound adjuster set (24) with a 17 mm open-ended wrench and unscrew
the locknut (27) with another 17 mm open-ended wrench.
• Remove the rebound adjustment set (24) and the locknut (27) from the pumping
element rod.
• Apply some stretched adhesive tape onto the end of the rod
(25) in order to cover the rod threading. Do not apply thick adhesive tape.
• Push the rod (25) towards the cartridge, up to removal.
The pumping element and the compression valve can be completely
overhauled and re-used. Section 4.7.2/4.7.3 explains the overhauling and
setting procedure for the pumping unit and the compression valve.
• Check the piston segment for wear.
Section 4.7.4 explains the procedure for re-assembling the cartridge unit and
compression valve
To Next Page
Loading...
