Huvitz Excelon XD - Page 107

106 Excelon XD/XQ Operator’s Manual
6.3.10.4 Drill Tip Axis Adjustment
Load “Drill Tip Angle Adj” data in the Job menu and then start processing.
Drill Tip Angle Adjustment Pattern
If the overlapped hole found, adjust “Drill Tip Angle Adj” value according to the
following table.
Overlapped holes
Compensation value
①,②
Current value - 0.5
③,④
Current value - 0.2
⑤,⑥
Keep the current value
⑦,⑧
Current value + 0.2
⑨,⑩
Current value + 0.5
If there are no holes which overlap on the front surface, increase or decrease the
“Drill Tip Angle Adj” parameter by angle value.
No
Diameter
(mm)
Tilting
(°)
①,③,⑤,⑦,⑨
0.8
0.0
②,④,⑥,⑧⑩
0.8
30.0
①,②
③,④
⑤,⑥
⑦,⑧
⑨,⑩