Frame Material, Lens Material and Lens Thickness may affect the quality of
Lens Fitting. If needed, execute the Size Adjustment in advance.
Frequently used Adjustment Value can be stored at “Frame Fitting” in “size
Adjustment”. (Refer to section 6.3.1)
• In the base curve mode, base curves of (+) lenses and (-) lenses exist the
opposite side of each of them. In this mode, the bevel or grooving line always
passes the mid of the thinnest area which is located at the midst zone of (-)
lenses and is located at the edged zone of (+) lens. And much bigger position
value makes the curve closer to the base curve.
• Be sure to carry out the Edging Process in Fragile Mode in case the
lens may be broken or the axis may be tilted during the edging
process.
• Grooving and Polishing is not available for the Glass Lens. Be sure the material
of lens is matched with the job options selected in the display before starting the
Edging Mode.
• Be sure to use the new Tape or Sticker and erase the wet from the Lens
surface.
To Next Page
Loading...
