Excelon Operator’s Manual 93
7.8 Maintenance Tips
▪ Wheel Replacement
It is recommended to keep the replacement cycle of Wheel in order to maintain
the Edging Performance.
• Replacement Cycle : 7,000 ~ 8,000 pieces of Lens edged
Be sure to replace the Finishing Wheel and Polishing Wheel at the same
time.
▪ Regular Maintenance
It is recommended to keep the regular maintenance cycle in order to maintain the
Edging Performance. Be sure to carry out the regular maintenance by the
service technician of Huvitz or the technician authorized by Huvitz.
• Regular Maintenance Cycle : 1,500 ~ 2,000 pieces of Lens edged
▪ Fuse Replacement
Be sure to check the Fuse Specification for the replacement job.
• Edger : 250V 10A . Frame Reader : 250V 3.15A . blocker : 250V 0.5A
• Be sure to use the appropriate Fuse. Otherwise it may damage the product or
cause the fire.
▪ Fuse Replacement in Edger and Frame Reader
To Next Page
Loading...
