Excelon Operator’s Manual 67
▪ Beveling
- Type : Set initial beveling option
- Default Value : Set initial bevel position values
▪ Grooving
- Type : Set initial grooving option
- Default Value : Set initial groove position values
▪ Safety Beveling (Chamfering)
- Bevel : Do Safety beveling or not after bevel process
- Rimless : Do safety beveling or not after rimless process
- Mode : Choose front & rear side or only rear side
- Default Value : Set initial values for the width of safety beveling for each side
and the style
To Next Page
