97
4. System Setup
Example (2) :
If interface select
Chuck open
M code (feed command)
Eject new bar with turret :
(Main program)
Chuck open
M code (feed command)
Chuck close
Cutting
/ M98 Pxx (go to sub program)
M99 (Return)
Pxx (Sub program)
Chuck open
** M code(feed command)
W – 100
(turret come to loading position)
M code(feed command)
Chuck close
Part off
M99(go to main program)
- If CNC interface provided with chuck open
signal and M code signal, normally “ By M code
finish signal “ will be used .
To Next Page
Loading...
