136
7. Alarm List
Alarm
No.
Alarm Picture Cause Action
30
Using Back stop,
pushrod can not
reach “ P “ position.
Check pushrod and spindle.
31
Push bar too long.
(1) Setting feeding with
turret function (on
3.5.2) but the turret
not in position.
(1) Check CNC program.
(2) Check “ Barfeeding with /
without turret ”
(on 3.5.2).
32
Bar too long.
Bar too long on the bar
rack, length over part off
value (F) (on 3.4.2 )
(1) Changing the position of
part off ( on 3.4.2 )
(2) Replacing the short bar
To Next Page
Loading...
