Hydrafeed MSV 65 - Page 149

146
8. Warning List
Warning
No.
Warning Picture Cause Action
16
CNC under chuck close
condition ,whether CNC
is stationary or rotating.
Select the actual status of
CNC
17
Under Sub spindle pull
function, DEMO
function will not work.
Turn off the switch of
Sub spindle pull function.
18
Impossible to operate manual mode
because cover is open.
Somebody opened the
cover or there is a
problem at the interlock
switch.
(when you select 4.9
Cover operation
function)
-Touch on <NEXT>.
-Close the cover.
-Check the interlock switch.