Hypertherm Koolant Koolers N-Series - Installation; 6.1 Checking for Shipping Damage

 SitePlanning‐LocationConsiderations 
13
5.2.2 Elevation
Thechillersareintendedtobeinstalledonthesamefloorlevelastheplasmacuttingsystem.Installationona
mezzanineisacceptableaslongastherequirementsidentifiedinSection5.2.3throughSection5.2.6aremet.

CAUTION
Thechillersarenotequippedwithananti‐backflowdevice.Installingthechilleratalower
elevationthantheplasmacuttingsystemorinstallingoverheadplumbingbetweenthechiller
andtheplasmacuttingsystemcancausethechillerfluidreservoirtooverflow.
5.2.3 ElectricalEn closure Clearance 
OSHAandtheNECbothmandateaminimumclearanceof36inchesonelectricalenclosuredoorsoflessthan
600voltsandlessthan65,000symmetricalfaultamps.

5.2.4 ServiceDoorClearance
Thechillersareequippedwithremovableservicedoorsononesideofthemachine.Atleast3feetofclearance
isrequiredbetweenthechillerandanyotherobstructionstoena bleservice accesstotheinternalcomponents
ofthechiller.

36
in
Hypertherm, Inc. Part Number: 810540