Hypertherm Koolant Koolers N-Series - Operation; 7.1 Pre-Startup

 Installation‐CoolantReservoirFilling 
23

Figure10:ChillerPlumbing&ElectricalConnectivity

6.9 CoolantReservoirFilling
Whenthechiller’splumbingconnectionshavebeeninstalledthereservoirmustbefilledwithPlasmaCutting
SystemManufacture’sre commendedcoolant.RefertoHyperthermequipmentcoolantrequirementsforproper
coolantrequirements.Donotusetapwater.
Tofillthechiller’scoolantreservoir:
1. Removethedoorpanel,sideblockerpanels,andupperblockerpanelasdescribedinSection6.4.2.
2. Removethefillportcapfromthetop ofthetank.
3. Fillthereservoirwiththemanufacturer’srecomme ndedfluidwhilemonitoringtheTankLevelSight
Gauge(RefertoFi
gure10).ThereservoirshouldbefilleduntilthelevelisneartheHighTankLevel
label.Thereservoircapacityis10.5gal(40L).
4. Reinstallthereservoirfillportcapandhandtighten.
5. Replacetheupperblockerpanel,sideblockerpanels,anddoorpanelasdescribedinSection6.4.2.

PROCESSFLUIDOUTLET
TANKLEVEL
SIGHTGAUGE

TANKDRAIN
PORT

INTERLOCKCONNECTION
ETHERNETCONNECTION
PROCESSFLUIDINLET
Hypertherm, Inc. Part Number: 810540