10 D0559 Rev. A SlideDriver/SlideDriver 50VF Series www.hysecurity.com
emergenCY stop Button
Make sure all users of the gate know where the emergency stop button
is located (see illustration). It complies with UL 325 Safety Standards
requirements.
Pressing the emergency stop button while the gate is opening or
closing disables the automatic close timer and stops gate travel. Gate
travel remains stopped until the operator receives another open or
close signal.
emergenCY release
Before attempting a manual release, make sure the gate is not in motion and power is disconnected
(turned OFF).
Make sure and teach all users how to turn off electric power and how to move the gate manually. To prepare for
manual operation, power must turned off
and the drive wheels must be released
Know the weight of the gate you are
moving. Excessively heavy gates can be
difcult to move and may cause serious
injury to those involved in moving the
gate. Take the necessary precautions when
manually moving any gate.
When releasing the handle inside the
chassis, be careful as the mechanism is
spring-loaded and drops rapidly. Hold the
handle appropriately so your ngers do not
get injured or pinched.
To disengage the drive wheels from the
drive rail and manually move the gate, take
the following steps:
1. Remove the front chassis cover and set it aside.
2. Pull the toggle handle down. The manual release is located under the electric control panel and to the
right of the hydraulic motors.
NOTE: For more information, refer to “Drive Wheel Spring Tension (Adjustment of Manual Release)” on page 87.
Other types of release mechanisms exist. For example, the Fire and Emergency Access Lock Box is available
through HySecurity distributors. Contact your distributor for more information.
Emergency Stop
button
Toggle Handle
clamped
Compression Spring:
Controls drive wheel gripping force. Set at 2 in.
(5cm) when Drive Wheels are clamped on the
Drive Rail. Toggle handle is in the clamped (load)
position.
Coupling Nut:
Adjusts compression spring.
Drive Wheels
Drive Rail
slides between
drive wheels
Note: Drive Rail must be aligned and secured before adjusting wheel loading
Toggle Handle
unclamped
To Next Page
Loading...
Need help?
General
