24 D0559 Rev. A SlideDriver/SlideDriver 50VF Series www.hysecurity.com
HYdraulIC Hose swap
Gate Handing is determined by viewing the gate opening from the secure side. If the gate opens to the left, the
gate must be set for left handing.
All SlideDrivers are set at the factory for right handing. If the gate has left handing, you must
• select SH L when prompted (or access the
Installer Menu)
• swap position of the hydraulic hoses.
adjustIng tHe pressure relIef valve
When placing the operator into service, pressure relief valve
adjustments are required! To provide instruction during
installation, a cautionary yellow tag is wire tied to every pump
pack. The same instructions are provided in this section.
Pressure relief valves differ depending on the model.
Tools Needed: 5/3 2 " hex key, ½" and 9/1 6 " box end wrenches.
NOTICE: Pressure relief valve adjustments establish the threshold for the inherent entrapment sensor (IES). The
optimal pressure setting produces uniform gate travel and trips the IES when the gate encounters an obstruction.
Model Motor hp Maximum PSI
SlideDriver 15, 40 1 hp 1000 psi
SlideDriver 30F, 80, 50VF 2 hp 1350 psi
SlideDriver 200 5 hp 2000 psi
Never exceed the maximum psi setting.
Factory set for right-handing.
Swap hose connections for
left-handing gate.
To Next Page
Loading...
Need help?
General
