HySecurity SlideDriver 15 Programming & Operation Manual

90 D0559 Rev. A SlideDriver/SlideDriver 50VF Series www.hysecurity.com
HYdraulIC sYstem maIntenanCe
Fluid Level: Under normal conditions, hydraulic systems do not consume uid. Check the system thoroughly for
leaks, before adding any uid. If uid needs to be added:
1. Remove the metal plug from the tank.
2. Use HySecurity Uniow hydraulic uid; part number
MX000970. Gallon sold by our distributors.
3. Fill to within ½ inch of the plug level, and then replace plug.
NOTICE: Never use brake uid. It will severely damage the hydraulic
system. Use of any uid other than uid recommended by HySecurity
may void the operator warranty.
Look for leaks: Occasionally there may be slight seeping at the
ttings after some usage. Tightening of the ttings usually corrects
the problem. If leaking persists, replace “O” rings, ttings or hoses,
if required. No further leaks should occur.
To Change Fluid: Unlike a gas engine, the uid inside a hydraulic
system does not foul, so uid changes do not need to occur often.
HySecurity recommends draining the reservoir and replacing the
uid at ve-year intervals. Fluid breakdown caused by heat is the
main concern. If the unit is subjected to high use, or you are using
the HySecurity biodegradable uid option (especially in a wgate climate), change
the uid more frequently.
To change the hydraulic uid,
1. Remove the reservoir from the pump pack.
2. Completely empty it.
3. Wipe the reservoir clean and clean the derby screen.
4. Re-assemble the pump unit and rell it with new Uniow hydraulic uid.
5. To avoid overlling, slowly pour the uid through the ller port near the
reservoir’s top until the uid is within one inch of the port’s opening.
6. Replace the plug and wipe up any spilled uid. Spilled uid dries to a
sticky and messy consistency.
Cold Weather Issues:
1. Check that your reservoir is lled with our Uniow high performance uid.
2. Excessive ice buildup can partially or totally jam gate operation. Operate the gate manually, while clearing
the ice buildup.
3. If the operator is located in an area of extreme snow conditions, regular maintenance to dig the operator
out may be required. A heater option may help.
NOTE: A biodegradable uid option does exist, but it does not have the same uid viscosity at extremely low
temperatures. Uniow uid temperature rating is between -40°F and 158°F (-40°C and 70°C). The biodegradable
uid has a temperature rating between -10°F and 158°F (-23°C and 70°C).
Pump
pack
Quick
Disconnect
Brake Valves
Solenoid
Locknut
The Pressure Relief
Valve is located
behind the
motor on the
pump pack or
soft start
manifold.
Motor
Pump
pack
Adjustment Screw
SlideDriver 15, 40, 50VF
Brake Valves

HySecurity SlideDriver 15 Specifications

General

Brand	HySecurity
Model	SlideDriver 15
Category	Gate Opener
Language	English