[Position]
Select the position to display the date & time on the images.
If the setting is to be transmitted to the camera, mark this item to select the display
position.
L-Upper/ L-Lower/ R-Upper/ R-Lower
â–
Camera selection
Select the camera to which the date & time display setting is to be sent. Mark the checkbox
of the camera to which the setup information is to be
transmitted.
[Transmission] button
Transmit the date & time setting to the camera. Once transmission is completed and the
setting has been applied to the camera, "OK" will be displayed in the "Results" field. If the
display reads "Authentication error", etc., the camera connection or the setting may have
failed.
[Back] button
Click the button after completing the settings. The screen returns to the [Camera setup]
tab.
Set up OSD [Display Title]
Determine whether to display the title and select the title to display for each camera, the
settings will be changed after the settings have been transmitted to the camera.
Clicking the [Setup >] button for "Display Title" on the [Camera setup] tab will display the
following items.
[Setup via recorder's main monitor]
29
To Next Page
Loading...
Need help?
General
