Since the parameters differ depending on the model, refer to the following section for
details.
☞
Advanced setup
Default: Cam.1
[Registration] button
Registers the set host information as a new.
■
Edit host information
Change or delete the registered host information.
Select a host information to change or delete on [Host IP address]. To edit items, proceed
as for new user registration.
[Edit] button
Registers the edited user information.
[Delete] button
Deletes the selected user.
Configure the settings relati ng to m aintenance [Maintenance]
The version of the recorder and disk information is displayed, and the settings relating to
hard disk drives can be configured on the setup menu - the "Advanced setup" menu - the
"Maintenance" page. It is also possible to initialize the setup data of the setup pages, check
the system logs and register the license on this page. The "Maintenance" page has [System
information], [HDD information] and [System management] tabs.
Check the system information such as the version [System information]
■
System information
The version (of the software and hardware), serial number, network information (MAC
address, IP address, line speed), temperature inside the recorder and highest temperature
inside the recorder, etc. are displayed on this tab.
[Setup via recorder's main monitor]
135