To Next Page

To Previous Page

2. Loosen the two wing nuts

3. Loosen the wing nut

and slide the bracket toward the back of the rail.

4. Remain at the back of the rack holding the support rail in position in the rack,

and then install and fully tighten the two mounting screws

5. Go to the front of the rack.

6. Extend the support rail toward the front of the rack.

Note: Hold the support rail in position until you have completed step 8.

7. Ensure that the support rail is horizontal (a level might be useful here).

8. Install the two mounting screws

into the third and fourth holes of the

support rail flange. Fully tighten the screws.

9. Fully tighten the two wing nuts

10. Loosen the wing nut

and slide the bracket toward the front of the rail as

far as it will go, with the front edge of the bracket against the back-end of the

front support rail.

Figure 83. Installing support rails for a 2145 UPS into the rack

122 IBM System Storage SAN Volume Controller: Hardware Installation Guide

Questions and Answers:

Need help?

Do you have a question about the IBM 2145UPS-1U and is the answer not in the manual?

IBM 2145UPS-1U Specifications

General