Press the right button to display the language that you want. When the required
language is displayed, press the select button.
Note: Line 1 of the menu displays an option. For some options, additional data is
displayed on line 2. If, the front panel is set to Japanese, Korean, or Chinese,
the menu shows only line 1. To display line 2, press the select button. To
return to the option on line 1, press the select button again.
The following languages are available:
v English
v French
v German
v Italian
v Japanese
v Korean
v Portuguese
v Spanish
v Chinese (simplified)
v Chinese (traditional)
If
you do not understand the language that is displayed, wait for at least 60
seconds for the menu to reset to the default option. To select the required
language, perform the following steps:
1. Press the up button once.
2. Press the select button once. If the display changes, go to step 5.
3. Press the up button once.
4. Press the select button once.
5. Press the right button until your required language is displayed.
6. Press the select button.
Note:
This procedure does not work if the node is displaying a boot error.
Appendix C. Using the front panel of the SAN Volume Controller 151
To Next Page
Loading...
Need help?
General
