IBM Aptiva Reference Guide

50
Solving software problems
The phone rings and the
computer comes out of
Standby, but a fax isn’t
received
•
The fax software must be open and set to receive
faxes. Refer to the documentation that came with
your fax software to make sure it is set up to answer
the phone.
•
In some cases, the computer may require additional
rings before a fax is received. Allow the phone to ring
a few more times.
•
Check the Wake Up On Ring cable from the modem
to the system board to ensure it is securely attached
(not all systems require this cable).
The computer won’t come
out of Standby on Wake
Up On Ring
1
Check the Wake Up On Ring cable from the modem
to the system board to ensure it is securely attached
(not all systems require this cable).
2
The modem software must be open when you put
your computer on Standby.
The computer won’t take
a message out of Standby
1
Check the Wake Up On Ring cable from the modem
to the system board to ensure it is securely attached
(not all systems require this cable).
2
The answering machine software must be open and
set to receive messages.
You pressed the system
On/Off button, but the
computer has not turned
off
•
Press the On/Off button on the front of the system
unit and hold it for 4-seconds.
•
If the computer does not turn off after 5 minutes, see
“HelpWare support and services” on page 79 for
information on obtaining service.
If the problem is... Here’s what to do...
Periodically use the IBM Update Connector to look for
available updates for the software that came from the factory
with your computer. For information about the IBM Update
Connector, see the Aptiva online help.
If any of these problems continue after taking the actions
listed, run the diagnostics programs that came with your
computer. If you need service, see “HelpWare support and
services” on page 79.
66xarg.book : 66xach3.fm Page 50 Tuesday, June 30, 1998 10:18 AM

IBM Aptiva Specifications

General

Brand	IBM
Model	Aptiva
Category	Desktop
Language	English